This Install Guide is intended to help with the installation of Agency Power Part# AP-MK7-110 Level of difficulty Step
1. Remove the small vacuum line located on the side of the factory airbox Step
2. Pinch the sides of the plastic connector and pull away from the airbox to remove the smog pump hose. (If the vehicle is equipped with a Smog Pump)
Step 3. Use a 7mm to loosen the clamp at the turbo housing.
Step 4. Remove the Torx screws on the lid of the factory air box and remove the upper intake lid and intake pipe from the vehicle.
Step 5. Remove the two T25 Torx screws holding the OEM scoop.
Step 6. Lift up on the coolant hose to remove it from the plastic taps
Step 7. Push down on the tabs while pushing inward to free the scoop from the clips on the radiator support. Remove the OEM Scoop from the vehicle.
Step 8. Lift up to remove the intake box from the vehicle. The box is held in place by rubber grommets.
Step 9. Attach the filter to the intake pipe. Use a 8mm nut driver to tighten the hose clamp.
Step 10. Install the Intake pipe and box into the vehicle. You will need to position the intake box sitting freely into the location of the factory air box. Lift up slightly on the airbox while inserting the pipe and filter into the intake box. See pictures for reference.
Step 11. Attach the intake pipe to the turbo inlet using the coupler and supplied hose clamps. Use a 8mm nut driver to tighten the clamp. Make sure the coupler is seated in place properly.
Step 12. Push down on the intake box to secure the box to the rubber grommets. Use the supplied hardware to bolt the intake pipe to the housing.
Step 13. Re-attach the smog pump hose and vacuum line to the air box
Step 14. Secure the intake box by reusing the T25 Torq screws that were removed during (STEP 5)