This DIY guide will help you with the installation of the Agency Power Carbon Fiber Rally Wing for the 2008-2014 Subaru WRX & STI Hatchback.
- 10MM Deep Socket
- 3″ or 4″ Extension
- Small Flat Head Screwdriver
- Phillip Screw Driver
- 3M Double Sided Tape
- Friend to assist
In order to access the hardware that secures the factory wing we will need to remove the plastic panels located on the inside of the rear hatch. Open the rear hatch and begin by carefully removing the three plastic interior panels located on the rear hatch. Start with the panel on the center and then remove the outer two side panels. They are held on by plastic clips and do not require much force to remove.
Now that we have the interior panels removed we can now access the third brake light wires and rear window washer lines, which will need to be disconnected. Using a small flat head screwdriver to assist, undo the third brake light wire connector.
Locate the rear window washer fluid hose coupler and pull to separate the lines from each other.
Next we will be removing the (4) 10MM bolts/nuts that secure the wing to the hatch. Even though the wing will still be attached with plastic clips it’s best to have a friend hold the wing in place just in case.
Once all the hardware is removed you can now softly close the rear hatch and lift up to remove the factory wing. Its best if you have a friend that can help you lift on each side. Lift up carefully to free from the plastic clips. As you are lifting the wing off, you will need to remove the rubber grommet securing the window washer fluid hose and third brake light wire. At this point the wing will be completely free from the vehicle.
Now that the factory wing is removed from the hatch of the subaru we will need to remove the third brake light and window washer fluid nozzle so that we can swap them over to the new Agency Power Carbon Fiber Rally Wing. Lay the wing on towel or something soft to avoid damaging the paint. Use a small flat screw driver to lift up and remove the plastic clips that cover the phillip head screws securing the third brake light to the wing.
Locate the wire connectors and unplug the the third brake light. Once unplugged you can now remove it from the factory wing.
Remove the the cap that holds the rear window washer nozzle. Use a flat head screw driver to carefully lift up and free it. Once it is free undo the hose separate the nozzle from the cap. We will be reusing only the black nozzle in the Agency Power Carbon Fiber Rally Wing.
Apply 3M double sided tape around the areas where the Agency Power Rally Wing will be contacting the hatch. This will secure the wing to the vehicle.
Now you can transfer the third brake light and washer nozzle over to the Agency Power Wing and reverse the to previous steps for installation. If you have any questions or need further assistance please call 480-921-7422 or email Sales@Agency-Power.com
Enjoy your Agency Power Carbon Fiber Rally Wing!